what is the world I’m jiggling and today I’m going to be Verizon some motorcycle pieces so as you can see here I finished will almost finish the rear section the tail the passenger seat the front fender the front headlight assembly front of the motorcycle more to cycle and then this side piece so now I’m going to be working on this one it’s going in Avery Dennison’s Avery Denison’s diamond blue and it’s gonna look absolutely ridiculous on this motorcycle as you can see I’ve already done the inlay here because the film isn’t going to stretch inside there or inside there so I had to put a little pre spretz piece on it but I have everything already cut up and I’m going to attempt to put all this piece on and see how good it turns up alright so what I’m gonna do now is I’m going to basically take this off put on the chair and peel the backing paper off the film and have the film sticking up so I’m basically doing it by myself and if I had extra help I can have it all one piece he didn’t do 2008 zx6r fairings the pre stretch but I can’t get any pre stretch someone’s gonna do what I can just put this over here I clean this it took me two hours this morning because motorcycles are dirty out on the chair grab my films the table is completely dried off completely clean I spent what 20 minutes making sure there was no specks and debris I’m just gonna get this corner and peel it back and yes I know this is not the proper way but I’m by myself whoa you now the film I’m just going to give it a quick heat rest doesn’t my audio might disappear so now they said it’s gonna lay it face down have enough coverage right yep extra room there excellent bottom then it perfect so I’m gonna do now I’m just basically going to just tack it to the film so I can put my hand and okay on that yeah I feel the wrinkles it’s I were come on up I just want to get it so I can flip the piece over and not have much issue so now it’s time stuff as you can see lift it up but now I’m going to flip the piece over and start laying down my first lines and I said this is blue diamond by Avery Dennison I picked this color because it has that sparkle and once you see ninja 300 fairings it when I’m complete in the Sun it’s absolutely mesmerizing make sure it’s all the way to the ends as you see I’m putting my hand right here because this will be my point of center that’d be the first piece I lay down and basically work off before quarters hey first I want to do good I’m gonna come this way first so I can exit with my body against it so I’m going to use my squeeze you know as you can see right here it’s a thick line I’m going through the windpipe bit more see right thing I’m starting to eat a little bit more thicker finger there I’m gonna hit right there I only had a bigger table Michael so
now I have the point of contact where everything from around there will all be based off the movements I use from this centerpiece so you’ll see some corners we have a lot of access and something morning we’ll have none just gonna fill this back so grab my squeegee and what’s not working from right there I’m just going to fill up the bunny let’s make sure I’m actually covered I think I’m gonna do this piece Birds get better smaller so I’m going to take line there don’t want to hurt it too much so I’ll just give a quick lift to make sure that all the air is released off the corners and doesn’t leave any fingers or blue marks only thing I’ll bring them in at this pace have a better life so I had the one and these lights up here but you can barely see so I’m working in my basement versus my garage but lighting is he so now basically this entire portion is stuff well other than me cutting the corners and tucking the film this must be the bottom portion of the motorcycle where the exhaust was basically melted to become close you can kind of see you right here that there’s chunks behind the foam and that’s just strictly the exhaust melted the films this entire bottom it will look a little bit kind of like this if you can really see it on the camera all yamaha r6 fairings the way around I’m just gonna just work past it and see what it turns out so right here bust one of those exhaust holes so from here I know that in order for me to get this all the way around to reduce the amount of wrinkles I’m gonna have to add some extra slack or I might get to the point where there’s no return I’ll have to cut a hole inside there and trying to pitch around these edges but I hope I can work around and not have to cut holes in pants like that but I think there’s no other way around it and the way I started moving the phone if I would have been taking it more of this angle across and tuck to them deeper versus come over here I wouldn’t have that but now I’m gonna have a major issue for this one an issue for this exhaust of course I might try something a little different since I laid my knifeless inside here I think I might be able to actually take some slack from here and tuck it inside there to keep this side foot flush I didn’t realize her out of stories my homes we pause a little bit but I did a little bit of work to it if you remember from this entire exhaust hole it was all crinkled up but I heated
the entire film and prestressed a little bit but I didn’t put that on camera because I don’t know it stopped but I got a couple wrinkles here and there so I forgot to pretty much read work those got this fake one right there I’m gonna start with that right there well this is the bottom of motorcycle where it’s melted arse again as you can see the lines are going this angle basically so this piece has to go this way it’s even the mouth but luckily since there’s so much air there’s not so much film buildup inside there I think I might be able to just put my hand under it and give it a little little touch and it’s hitting harder than I thought so once again it’s me cuz whenever in doubt hit it with some heat and 2007 gsxr 600 fairings it will give you the best maneuverability of the phone they see here also the motorcycle has more debris I guess you can call it that’s actually on the motorcycle itself and the vinyl is pretty much just letting you know it’s there now the last little section about this Bay five inches there’s so many angles in this piece it goes four different directions and it’s hard to side which direction I want to take the phone so my heat it up again and try and that’s it that is how you wrap a motorcycle but I’m just gonna do all the rest of this trim work I’ll off camera just for the fact that it’s boring part of it yeah this is a Vaughn erect motorcycle piece by lawless rap aka Julian Lawson tip until next time peace
